THOMSON TG605s - Ip Ifconfig

ip Commands
516
E-DOC-CTC-20080409-0002 v2.0
ip ifconfig
Modify an IP interface configuration.
SYNTAX:
ip ifconfig intf = <{loop|ipsec0|lan1|wan1|dmz1|guest1}>
[mtu = <number{68-65535}>]
[status = <{down|up}>]
[hwaddr = <hardware-address>]
[group = <{wan|local|lan|tunnel|dmz|guest} or
number>]
[linksensing = <{disabled|enabled}>]
[primary = <{disabled|enabled}>]
[mcastpromisc = <{disabled|enabled}>]
[symmetric = <{disabled|enabled}>]
where:
intf An IP interface name. REQUIRED
mtu The maximum packet size (including IP header)
to use on this interface.
OPTIONAL
status The administrative state of the interface. OPTIONAL
hwaddr The hardware address (e.g. Ethernet MAC
address) of this interface.
OPTIONAL
group The group this interface belongs to. Can be used
by e.g. firewalling.
OPTIONAL
linksensing The IP interface's awareness of link state
transitions.
OPTIONAL
primary Make the IP interface the primary interface. OPTIONAL
mcastpromisc Make the IP interface multicast promiscuous. OPTIONAL
symmetric The routing mode of the IP interface. OPTIONAL