THOMSON TG605s - Eth Filter Template Config

eth Commands
E-DOC-CTC-20080409-0002 v2.0
341
eth filter template config
Config a filter.
SYNTAX:
eth filter template config filter = <{}>
[location = <{Ingress|Egress|VID|Priority}>]
[level = <number{0-65535}>]
[tracing = <{disabled|enabled}>]
[mark = <{disabled|enabled}>]
where:
filter The name of an filter. REQUIRED
location The filter location. OPTIONAL
level The filter level (lower level is processed first =
priority)
OPTIONAL
tracing Enable/disabled tracing of packets OPTIONAL
mark Enable/disabled marking of packets OPTIONAL