THOMSON TG605s - Grp Commands

grp Commands
E-DOC-CTC-20080409-0002 v2.0
429
grp Commands
grp config Set the grp configuration settings. see page 430
grp flush Flush grp interface settings and
parameters.
see page 431
grp ifconfig Configure routing parameters of an
interface.
see page 432
grp iflist Show the current interfaces. see page 433
grp rip bnadd Add an IP address to the RIP black
network list.
see page 434
grp rip bndelete Delete an IP address from the RIP
black network list.
see page 435
grp rip bnlist List the RIP black neighbor list. see page 436
grp rip config Set the RIP configuration settings. see page 437
grp rip flush Flush RIP interface settings and global
parameters.
see page 438
grp rip ifconfig Configure a RIP interface. see page 439
grp rip nbadd Add a RIP neighbor to the neighbor
list.
see page 440
grp rip nbdelete Delete a RIP neighbor from the
neighbor list.
see page 441
grp rip nblist List the RIP neighbor list. see page 442
grp rip rtfadd Add a route filter to the RIP route filter
list.
see page 443
grp rip rtfdelete Delete a route filter from the RIP route
filter list.
see page 444
grp rip rtflist List the RIP route filter list. see page 445
grp rip show Show the RIP settings and the routes
in the RIP database.
see page 446
grp rtlist Show the current routes in the grp
routing table.
see page 447
grp rttadd Add a translation rule to the grp route
translation list.
see page 448
grp rttdelete Delete a translation rule from the grp
route translation list.
see page 449
grp rttlist List the grp route translation list. see page 450