THOMSON TG605s - Page 972

xdsl Commands
972
E-DOC-CTC-20080409-0002 v2.0
[simulate-lp = <{disable|enable}>]
[vendor-specific = <string>]
where:
name The name of a DSL-interface profile. REQUIRED
paffragmentsize The PME Aggregation Function (PAF) fragment
size: 64..512 octets and multiple of 4.
OPTIONAL
annex ITU-T G.992.1 Annex A&F | ITU-T G.992.1 Annex
B&G.
OPTIONAL
minbw The minimum bandwidth at which the DSL
modem should initialize.
OPTIONAL
maxbw The maximum bandwidth at which the DSL
modem should initialize.
OPTIONAL
linecode The linecode used for data-transfer: 16-TCPAM
or 32-TCPAM (Trellis Coded Pulse Amplitude
Modulation).
OPTIONAL
margincurrent Is a set margin (db) that the noise may
increase (and as a consequence the SNR may
decrease) but at which the modem must remain
synchronized. Current noise margin value (dB).
OPTIONAL
marginworst Worst noise margin value (dB). OPTIONAL
margincurrentenable Enable/disable marginscurrent. OPTIONAL
marginworstenable Enable/disable marginsworst. OPTIONAL
monitoring Enable/Disable Transmission Quality (SNR)
monitoring.
OPTIONAL
atmupfast Enable or disable the local ATM TC layer at the
beginning of SHDSL training.
OPTIONAL
automaster Enable or disable Auto Master detection in 4
wire enhanced mode.
OPTIONAL
fastdrop Enable or disable line dropping if SNR drops
below 0dB.
OPTIONAL
force-enhanced Enable or disable use of enhanced four wire
mode only.
OPTIONAL
force-shdsl Enable or disable use of SHDSL only (no SHDSL-
bis).
OPTIONAL
force-tcpam16 Enable or disable use of the 16-TCPAM linecode
only.
OPTIONAL
force-tcpam32 Enable or disable use of the 32-TCPAM linecode
only.
OPTIONAL