215
OPUS Projektor Manual
Variables
"On time in one beeper interval"
Time in interval where beeper is switched on [ms]
One interval consists of @BeeperOnTime + @BeeperOffTime
Note: On devices with a speaker, short interval times (less than 300ms) might not trigger
the speaker at the beginning of the pattern.
"Off time in one beeper interval"
Time in interval where beeper is switched off [ms]
One interval consists of @BeeperOnTime + @BeeperOffTime
Note: On devices with a speaker, short interval times (less than 300ms) might not trigger
the speaker at the beginning of the pattern.
"Writing: Number of intervals to perform Reading: Beeper active/non-active"
Beeper will repeat sequence of @BeeperOnTime followed by @BeeperOffTime for
@BeeperRepetitions times
This will only succeed if beeper is not occupied by higher priority beeps originating from
To Next Page
Loading...