216
OPUS Projektor Manual
Variables
alarms.
Beeper priorities are:
- Key click (lowest)
- Event based beep patterns
- these variables
- Control audio command (sent to ISO VT)
- Alarms (with respect to their beep priority, highest)
Value is 0 if the beeper is not active. Value is -1 if the beeeper is active.
Note: On devices with a speaker, short interval times (less than 300ms) might not trigger
the speaker at the beginning of the pattern.
"Switch beeper on or of for a click"
There should be no need for customers to use this variable. To enable the "click" feature,
just apply a proper value to @BeeperClickVolume variable.
The click sound can be enabled by setting this variable to 1 with the volume set in
@BeeperClickVolume. But only if it was not turned on by a higher priority before (higher
priorities are: event -> VT -> Alarm).
The sound will automatically be switched off after 200ms (this variable will be reset to 0).
"Switch beeper on or of for an alarm"
Setting to 1 will switch the beeper with volume @BeeperAlarmVolume on. Switching this
variable to one will turn all other "@BeeperXXXOn" variables to 0.
Setting 0 to this variable will switch the beeper off.
To Next Page
Loading...