Topcon OPUS A6G2 - Page 217

217
OPUS Projektor Manual
Variables
Index
Subin
dex
Stora
ge
Type
Lengt
h
Acces
s
Type
Rema
nent
Force
Writin
g
Initiali
ze as
Invali
d
Defaul
t
Value
Min
Value
Max
Value
0x20d
0
0xb
Integer
2 Bit
Read/
Write
disabl
ed
enable
d
enable
d
0
-1
1
Supported on Platforms:
i.MX 35
i.MX 6 A-Series
i.MX 6 B-Series
ISOBUS
Yes
Yes
Yes
Yes
@BeeperEventOn
"Switch beeper on or of for an event"
Setting to 1 will switch the beeper with volume @BeeperEventVolume on, but only if it was
not turned on by a higher priority before (higher priorities are: VT -> Alarm).
Setting 0 to this variable will switch the beeper off (if no higher priority variable is == 1).
Index
Subin
dex
Stora
ge
Type
Lengt
h
Acces
s
Type
Rema
nent
Force
Writin
g
Initiali
ze as
Invali
d
Defaul
t
Value
Min
Value
Max
Value
0x20d
0
0xc
Integer
2 Bit
Read/
Write
disabl
ed
enable
d
enable
d
0
-1
1
Supported on Platforms:
i.MX 35
i.MX 6 A-Series
i.MX 6 B-Series
ISOBUS
Yes
Yes
Yes
Yes
@BeeperVariableVolume
"Set beeper volume to be used by @BeeperRepetitions"
Percentage of @BeeperMaxVolume to be used for @BeeperRepetitions
0: no beep on repetitions
Index
Subin
dex
Stora
ge
Type
Lengt
h
Acces
s
Type
Rema
nent
Force
Writin
g
Initiali
ze as
Invali
d
Defaul
t
Value
Min
Value
Max
Value
0x20d
0
0xd
Integer
8 Bit
Read/
Write
enable
d
enable
d
enable
d
0
-1
100
Supported on Platforms:
i.MX 35
i.MX 6 A-Series
i.MX 6 B-Series
ISOBUS
Yes
Yes
Yes
Yes
@BeeperAlarmPattern
"Run an alarm's beep pattern"
When setting a value to this variable, a beep pattern is played on the device's beeper. The
pattern is bitwise encoded into the value of this variable (20 values for on and off).