The angle of a gauge can be changed with the Angle property.
For the full Gauge, Start and End Angle can be modified to change the range of the
instrument as needed.
For the other Gauges, only the Start Angle can be modified. The End Angle will be
calculated depending on the range of the gauge (270, 180 or 90 °).
Start Angle
The start angle of the meter can be defined with this property.
The start angle's 0° position is at 3 o clock.
Default value: 0°
Possible values: 0° ... 360°
See examples above
End Angle
The end angle of the meter can be defined with this property.
The start angle's 0° position is at 3 o clock.
Default value: 0°
Possible values: 0° ... 360°
See examples above
Deflection Direction
The deflection direction defines how the value grows in the gauge. Either clockwise or anti
clockwise.
Default value: ClockWise
Possible values: ClockWise or AntiClockWise
Needle Color (Theme dependent)
With this property the color of needle can be defined.
Note: This property has no effect if a Needle Image is used.
Note: See also common properties Color Above Maximum and Color Below Minimum
which also have an influence on the needle color.
Default value: White (RGB 255,255, 255, 255)
Possible values: Any 24Bit ARGB color
Needle Image (Theme dependent)
Instead of the automatically drawn needle, a needle image can be assigned to the gauge to
show a different kind of indicator.
The needle image should have the same size as the gauge and the needle in the image
should always point to the 3 o'clock position.
Note that the image will be rotated around its center, so place the needle accordingly.
Example needle image:
To Next Page
Loading...