Topcon OPUS A6G2 - Page 487

487
OPUS Projektor Manual
Object Reference
Name
Type
Events / Actions
Description
Command: shuffle
Value: Value Not Set
shuffle graphics depending on the
pressed state.
9
Loop
List
OnValueChange
Set Media Player
Command
Command: loop
Value: Value Not Set
By executing the "loop" command,
the next loop mode will be applied.
The inital loop mode is 2.
This list shall have three picture
graphics as children. Each
represents a different loop mode:
At value 0: Loop off
(image shows a not-closed ellipse)
At value 1: Loop current file
(image shows ellipse with two
arrow heads)
At value 2: Loop all (when end of
playlist was reached, jump to start
of playlist)
(image shows ellipse with one
arrow head)
10
Volume
Decrease
Button
OnRelease
Set Media Player
Command
Command: set volume
Value: -10
When executing the "set volume"
command without a value, the
current value of the volume
bargraph (12) is used to set the
volume of the current playback. If a
value is provided, this value is
used to set the volume of the
current playback. The volume
bargraph will then be updated with
the set value.
The volume settings will also work
if currently no media file is
selected, they will be applied as
soon as a media file is set. The
volume settings are applied to all
media files of this multimedia
player and are not specific to one
certain file.
11
Volume
Increase
Button
OnRelease
Set Media Player
Command
Command: set volume
Value: +10
12
Volume Bar
Linear
Bargrap
h
OnValueChange
Set Media Player
Command
Command: set volume
Value: Value Not Set
13
Volume
ON/OFF
Button
OnPress
Set Media Player
Command
Command: mute
Value: Value Not Set
OnRelease
When executing the "mute"
command, the volume of the
currently played back media file is
internally set to 0. The value of the
volume bargraph (12) will not be
changed and remains the same.