Topcon OPUS A6G2 - Page 627

627
OPUS Projektor Manual
Device Software Update
Legend:
(1) When the agree checkbox is checked, the Proceed button will be enabled.
(2) If Proceed button is pressed you will see the CAN Settings Page.
(3) With Cancel you get back to Start Page.
NOTE:
When the Tool is started and you want to transfer a project via CAN bus you have
to accept the CAN Disclaimer once.
The next time in this Tool session the CAN Disclaimer will not be visible again.
PC CAN Settings Page
These settings will be used for the current project transfer. The settings shown here
have to be same as they were configured for the device, otherwise the transfer will not
work.
618