Note: The sensor and output resolution presets are currently designed to work with an
Orlaco Emos camera. Not all presets can be combined with this camera. A warning will
be displayed if a resolution combination will not work for that camera. Other cameras
might support that combination so it is still possible to apply this to the camera. Note the
error output in the Log window for error messages.
When pressing the OK button, the ROI settings from the wizard will update the settings in
the Regions of Interest tab of the tool itself. Press the Apply... button to save it to the
camera.
The Manufacturer Specific tab contains settings for a certain camera manufacturer.
The settings that can be made here are not part of the ISO 17215 standard. Therefore
special implementations for every camera manufacturer and even model need to be
implemented.
Currently only settings specific to an Orlaco EMOS camera are supported. If
manufacturer settings for other brands and models are needed please contact support.
Warning: These settings should only be changed if the meaning of the settings
are very clear and match the target / configuration platform. Setting a wrong
value here might make the camera unresponsive and not being able to work or
be configured after that! Changing settings here is on your own risk. The
provider of this tool is not responsible for any harm that a misconfiguration may
cause!
Orlaco EMOS
Only change the settings in this tab if an Orlaco EMOS camera is connected and
selected. When enabling the I am sure that this is an Orlaco EMOS camera check
box, the current settings are downloaded from the camera and can be changed. Every
setting needs to be changed separately with the matching Set button. After the Set
button was clicked, the field will be cleared and the new setting will be downloaded from
the camera. Watch the Log section for error messages.
Note that some of the settings will only have an effect after switching the camera off and
on again.
To Next Page
Loading...