Toshiba E-Studio 5540c - Detection of Abnormality; Types of Abnormality; Description of Abnormality; Add Paper

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
3 - 52
3.7.3 Detection of Abnormality
When something abnormal has occurred in the equipment, symbols corresponding to the type of
abnormality are displayed.
[ 1 ] Types of abnormality
1. Abnormalities cleared without turning OFF the door switch
(A) Add paper
(B) Paper misfeed in bypass
(C) No toner in the cartridge
2. Abnormalities not cleared without turning OFF the door switch
(D) Misfeed in equipment
(E) Waste toner box replacement
3. Abnormality not cleared without turning OFF the main power switch
(F) Call for service
[ 2 ] Description of abnormality
[A] Add paper
[In case of the equipment, tandem LCF] (When a drawer is installed)
Based on the combination of the tray-up motor (M44, M45) movement and the status of the tray-up
sensor and empty sensor, The CPU detects the presence of paper.
• [In case of the equipment drawer or PFP drawer] (When no drawer is installed)
Drawer not detected

Drawer is not installed:
Drawer is installed but there is no paper in it:

No paper

A signal sent to the control circuit

Drawer area of the control panel blinks
(When the drawer is selected)

[START] button is disabled.