Toshiba E-Studio 5540c - Original Exit;Reverse Sensor

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 297
4.11.47 Original exit/reverse sensor (SR11)
(3) Remove 1 screw and take off the sensor
cover.
Fig. 4-866
(4) Disconnect 1 connector and take off the
original tray width sensor.
Fig. 4-867
(1) Take off the platen sheet unit.
 P. 4-261"4.11.8 Platen sheet unit"
(2) Remove 1 screw and take off the locking
lever on the front side. Remove 1 screw and
take off the locking lever on the rear side.
Remove 1 spring and take off the locking
bracket.
Fig. 4-868
Locking lever
Locking lever
Spring
Locking Bracket