Toshiba E-Studio 5540c - IH Cooling Fan-1; IH Cooling Fan-2

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 203
4.9.21 IH cooling fan-1 (F8) / IH cooling fan-2 (F9)
(4) Disconnect a connector of the exit paper
cooling fan (rear).
(5) Remove 2 screws and take off the duct.
Fig. 4-588
(6) Release the harness [1] of the paper cooling
fan (rear).
(7) Release 7 hooks to take off the duct cover
[2].
(8) Take off the exit paper cooling fan (rear) [3]
from the duct.
Fig. 4-589
(1) Open the SYS board case.
 P. 9-2"9.1.3 SYS board case"
(2) Take off the IH board cover.
 P. 4-197"4.9.16 IH coil"
(3) Remove 2 screws each and take off the IH
cooling fan-1 and IH cooling fan-2.
Fig. 4-590
Duct
[
1
]
[
2
]
[
3
]
IH cooling fan-1IH cooling fan-2