Toshiba E-Studio 5540c - Bridge Unit Lower Cover

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 215
4.10.13 Bridge unit lower cover
(1) Open the front cover and then pull out the
bridge unit.
(2) Open the bridge unit lower cover. Then
remove 1 screw and the wire.
Fig. 4-623
(3) Remove 1 clip and then take off the bridge
unit lower cover by sliding it.
Fig. 4-624
Notes:
The leaf springs with the idling rollers are
usually not needed to be disassembled,
however, if they are removed and installed,
fix the screws while pushing the rollers in the
direction of the arrow in the figure to prevent
the exit paper side deviation.
After the rollers are installed, check that the
rollers are parallel to the installation holes.
When pressing the idling rollers, press them
in the direction opposite to each other
because the 2 leaf springs must be installed
in that manner.
Fig. 4-625
Bridge unit lower cover
Bridge unit lower cover