Toshiba E-Studio 5540c - Original Reverse Motor; Original Exit Motor

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 283
4.11.28 Original reverse motor (MR3)
4.11.29 Original exit motor (MR4)
(1) Take off the RADF rear cover.
 P. 4-258"4.11.3 RADF rear cover"
(2) Disconnect 1 connector.
(3) Remove 3 screws and take off the original
reverse motor with the bracket.
Fig. 4-825
(4) Remove 2 screws and take off the bracket
from the original reverse motor.
Fig. 4-826
(1) Take off the RADF rear cover.
 P. 4-258"4.11.3 RADF rear cover"
(2) Disconnect 1 connector [1].
(3) Remove 1 spring [2].
(4) Loosen 2 screws [3].
Fig. 4-827
Connector
[3]
[2]
[1]
[3]