11
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
FIRMWARE UPDATING
11 - 41
11.4.4 Saddle stitcher firmware (MJ-1104)
Important:
• Be sure to shut down the equipment before installing and removing the download jig.
• Do not shut down the equipment during the update. The data could be damaged and not be
able to be operated properly.
[A] Update Procedure
(1) Install the ROM to the download jig (K-PWA-DLM-320).
Make sure the direction is correct.
(2) Press the [ON/OFF] button on the control panel to shut down the equipment.
(3) Open the front upper cover and then pull out the saddle unit.
(4) Loosen 2 screws and turn the saddle control PC board access cover in the direction of the arrow.
Fig.11-33
(5) Connect the download jig with the jig connector (CN16) on the Saddle control board.
Fig.11-34
(6) Press the [ON/OFF] button while simultaneously holding down the [0] and [8] buttons.
Updating starts and the LED on the download jig lights.
Saddle control PC board access cover
Download jig
To Next Page
Loading...
