Toshiba E-Studio 5540c - Drum Surface Potential Sensor (K) (S34)

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 109
4.6.22 Drum surface potential sensor (K) (S34) (e-STUDIO6550C/6570C
only)
(1) Take off the solenoid holder.
 P. 4-107"4.6.21 V0 sensor shutter
solenoid (K) (SOL) (e-STUDIO6550C/6570C
only)"
(2) Rotate the holder slightly to take off the drum
surface potential sensor board with the
holder.
Fig. 4-318
(3) Remove 1 spring, lift up the shutter by
holding its end, and then slide it to take it off.
Fig. 4-319
(4) Release 2 hooks and then take off the drum
surface potential sensor.
Fig. 4-320
Holder
Shutter
Spring
Drum surface potential sensor