Toshiba E-Studio 5540c - Fuser Belt Thermostat

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 189
4.9.11 Fuser belt thermostat (THMO4)
(1) Take off the pressure roller cover.
 P. 4-173"4.9.2 Pressure roller cover"
(2) Take off the transport guide-1.
 P. 4-174"4.9.3 Transport guide-1"
(3) Take off the transport guide-2.
 P. 4-174"4.9.4 Transport guide-2"
(4) Take off the rear plate.
 P. 4-176"4.9.7 Separation plate"
(5) Take off bracket of the fuser belt rotation
detection sensor.
 P. 4-188"4.9.10 Fuser belt rotation
detection sensor (S49)"
(6) Remove 2 screws and take off the harness
guide-2 [1].
Notes:
When installing, do not let the harness be
caught.
Fig. 4-547
(7) Remove 2 screws and take off a sensor
bracket stay [1].
Notes:
Do not press the sensor bracket against the
fuser belt.
Fig. 4-548
[
1
]
[
1
]