Toshiba E-Studio 5540c - Enable HDD Encryption; Initialize Settings When FAX Unit Is Installed; Set Date and Time

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS/HDD
9 - 40
[L] Enable HDD encryption
If you use the HDD encryption function, follow the procedure below.
(1) Start up with the Setting mode (08).
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(3) Enable the HDD encryption function. Set the value of 08-8911 to “3”, or the value of 08-8911 to
“1” and 08-9379 to “1” or “2”.
(4) Turn the power OFF.
[M] Adjust image quality
(1) Start up with the Adjustment mode (05).
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(3) Perform “Data transfer of characteristic value of scanner” (05-3203).
(4) Perform “Automatic gamma adjustment” <PPC> (05-7869).
 P. 6-31"6.2.1 Automatic gamma adjustment"
(5) Perform “Automatic gamma adjustment” <PRT> (600dpi: 05-8008, 1200dpi: 05-8009).
 P. 6-49"6.3.1 Automatic gamma adjustment"
(6) Turn the power OFF.
[N] Initialize settings when FAX Unit (GD-1270) is installed
(1) Reinstall the FAX Unit (GD-1270).
(2) Start up with the Setting mode (08).
(3) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(4) Set the destination of FAX (08-9001).
(5) Turn the power OFF.
(6) Start up with the FAX Clearing Mode (1*).
(7) Perform the FAX Set Up (1*-100).
(8) Turn the power OFF and then back ON.
(9) Set the dial type according to these buttons: [USER FUNCTIONS] -> [ADMIN] -> [FAX] ->
[INITIAL SETUP]
[O] Set date and time
Set the date and time according to these buttons.
[USER FUNCTIONS]  [ADMIN]  [GENERAL]  [CLOCK]  [DATE/TIME]