Toshiba E-Studio 5540c - Operation Procedure in Setting Mode

5
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SELF-DIAGNOSTIC MODE
5 - 17
5.8 Operation Procedure in Setting Mode (08)
Procedure 1
* Press [FUNCTION CLEAR] to enter minus (-).
Procedure 2
Procedure 3
Procedure 4
* Press [FUNCTION CLEAR] to enter minus (-).
Procedure 5
Procedure 9
(Stores value in RAM)
[0][8]
[POWER]
[POWER] OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[Digital key]
*
[FUNCTION CLEAR]
[OK]
or
[INTERRUPT]
Sets or
changes value
[CLEAR]
(Corrects value)
[CANCEL]
[0][8]
[POWER]
[POWER]OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[OK]
or
[INTERRUPT]
Adjustment value
cannot be changed
[0][8]
[POWER]
[POWER] OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[CANCEL] or [CLEAR]
(Automatic setting)
[INITIALIZE]
or
[INTERRUPT]
(Stores value in RAM)
[0][8]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Sub-code)
[Digital key]
*
[FUNCTION CLEAR]
Sets or
changes value
[START] [START]
[OK]
or
[INTERRUPT]
(Stores value
in RAM)
[CLEAR]
(Corrects value)
[CLEAR]
(Corrects value)
[START]
[CANCEL]
[0][8]
[POWER]
[POWER] OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
[START]
[CANCEL]
[OK]
or
[INTERRUPT]
[CLEAR]
(Corrects value)
(Stores value in RAM)
Sets or
changes value
[0][8]
[POWER]
[POWER] OFF/ON
(Exit)
[Digital key]
(Code)
[Select button]
[START]
[CANCEL]
[OK]
or
[INTERRUPT]
[CLEAR]
(Corrects value)
(Stores value in RAM)