Toshiba E-Studio 5540c - Operation of Bypass Pickup Roller

3
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
OUTLINE OF THE MACHINE
3 - 75
[ 2 ] Operation of bypass pickup roller
When the bypass pickup solenoid (SOL8) is turned ON, the plunger is pulled, and then the lever is
rotated. The pickup arm is then brought down with its own weight. When the bypass pickup solenoid
(SOL8) is turned OFF, the pickup arm is brought up by the spring force.
The driving force transmitted through the bypass motor (M12) is transmitted to the bypass feed roller
through the shaft and then to the bypass pickup roller through the timing belt. The roller is rotated by
this driving force.
Fig. 3-44
Bypass motor(M12)
Bypass pickup solenoid(SOL8)
Bypass paper sensor(S71)
Bypass paper size detection sensor(S70)
Bypass feed sensor(S72)
Bypass pickup roller
Bypass feed roller
Bypass separation roller
Bypass transport roller
Pickup arm