e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 322
8.5.18 Poor transfer
Fig.8-26
Cause/Section Step Check item Measures
Transfer unit 1 Is the transfer belt or 1st/2nd transfer
rollers dirty?
Clean it.
2 Is the transfer belt in proper contact
with the drum?
Correct it.
3 Is the 2nd transfer roller in proper
contact with the transfer belt?
Correct it.
4 Is there any deformation or
abnormalities on the transfer belt?
Replace the belt.
5 Is the 2nd transfer facing roller dirty? Clean the 2nd transfer facing roller
and the transfer belt.
Replace the cleaning pad.
Paper 6 Is the high-voltage fed to the 2nd
transfer roller correctly?
If any contact failure occurs in the
feeding area (e.g. the conductive
bushing and spring come off), correct
it.
7 Is paper in the drawer or LCF curled? Reinsert paper with reverse side up
or change paper.
8 Is paper in the drawer or LCF damp? Change paper.
Avoid storing paper in damp place.
Registration
roller
9 Is the registration roller
malfunctioning?
Clean the roller, remount the spring,
or replace defective motor-related
parts.
High-voltage
transformer
(1st/2nd
transfer roller
bias)
10 Is the high-voltage transformer output
defective?
Check the circuit and adjust the
transformer output.
11 Are the high-voltage harness and
terminals in proper contact?
Correct them if loosened.
To Next Page
Loading...
