Toshiba E-Studio 5540c - Image Position of Secondary Scanning Direction

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING ADJUSTMENT
6 - 20
[D] Image position of secondary scanning direction (Laser writing start position)
Performing the code 05-4402 covers this adjustment for all paper sources.
The adjustment for each paper source is also available.
For all paper sources
For each paper source
<4-drawer model>
<Tandem LCF model>
1. While pressing [0] and [5] simultaneously, turn the power ON.  (Adjustment Mode)
2. Press [98] ([3] for duplexing)  [FAX]. (A grid pattern with 10 mm squares is printed out.)
3. Measure the distance D from the leading edge of the paper to the 6th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
* At the duplexing, measure it on the top side of the grid pattern.
4. Check if the distance D is within 52±0.5 mm.
5. If not, use the following procedure to change values and measure the distance D again.
<Procedure>
(Adjustment Mode)  (Key in the code shown above)  [START]
 (Key in an acceptable value shown above)
 [OK] or [INTERRUPT] (Stored in memory)
 “100% A” is displayed
 Press [98] ([3] for duplexing)
 [FAX]  (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance D becomes
(approx. 0.10 mm/step).
Code Paper size Acceptable value Remarks
4402 A3/LD 0 to 200 Performs the adjustment for all paper sources.
Order for
adjustment
Paper source Code Paper size
Acceptable
value
Remarks
1 1st drawer 4058 A4/LT 0 to 100
2 2nd drawer 4059 A3/LD 0 to 100
3 3rd drawer 4060 A4/LT 0 to 100
4 4th drawer 4560 A4/LT 0 to 100
5 Bypass feed 4061 A4/LT 0 to 100
6 Duplex feeding 4062 A3/LD 0 to 100 Paper fed from the 2nd drawer
7
Option LCF 4063 A4/LT 0 to 100
Only when the optional LCF is
installed
Order for
adjustment
Paper source Code Paper size
Acceptable
value
Remarks
1 1st drawer 4058 A4/LT 0 to 100
2 2nd drawer 4059 A3/LD 0 to 100
3 Tandem LCF 4561 A4/LT 0 to 100
4 Bypass feed 4061 A4/LT 0 to 100
5 Duplex feeding 4062 A3/LD 0 to 100 Paper fed from the 2nd drawer
6
Option LCF 4063 A4/LT 0 to 100
Only when the optional LCF is
installed