Toshiba E-Studio 5540c - Fuser Belt Thermopile; Fuser Motor

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 199
4.9.17 Fuser belt thermopile (THMP1)
4.9.18 Fuser motor (M6)
(1) Take off the fuser unit.
 P. 4-172"4.9.1 Fuser unit"
(2) Remove 1 screw and take off the sensor
bracket.
(3) Release the harness from 4 clamps.
(4) Remove 1 screw and connector take off the
fuser belt thermopile [1].
Fig. 4-576
(1) Open the SYS board case.
 P. 9-2"9.1.3 SYS board case"
(2) Release a harness from 2 clamps.
Fig. 4-577
(3) Remove 2 screws and take off the motor
bracket [1].
(4) Disconnect a connector of the exit paper
cooling fan (rear).
(5) Remove 2 screws and take off the duct [2].
(6) Disconnect a connector [4] from the fuser
motor [3].
(7) Remove 2 screws and take off the fuser
motor [3].
Fig. 4-578
[
1
]
[
1
]
[
2
]
[
3
]
[
4
]