Toshiba E-Studio 5540c - Tray-Up Motor-1

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 75
4.5.46 Tray-up motor-1 (M44)
(3) Disconnect 1 connector[1].
Remove 1 bushing[4] and 2 clips[3].
Take off the 4th drawer transport clutch[2].
(4) Disconnect 1 connector[5].
Remove 1 bushing[4] and 2 clips[3].
Take off the 4th drawer feed clutch[6].
Fig. 4-218
Notes:
1. When installing, be sure to align the
protrusion of the clutch to the position
shown in the figure.
2. The color of the harnesses for the drawer
transport clutch and for the drawer feed
clutch is different. When installing, be
sure to attach the corresponding harness.
Yellow: 4th drawer transport clutch[1]
Blue: 4th drawer feed clutch[2]
Fig. 4-219
(1) Remove the 1st and 2nd drawers.
(2) Take off the PFC board case.
 P. 9-8"9.1.9 PFC board case"
(3) Disconnect 1 connector and remove 4
screws. Then take off the tray drive unit [1].
Fig. 4-220
[1]
[2]
[3]
[3]
[4]
[4]
[5]
[6]
[1]
[2]
[
1
]