Toshiba E-Studio 5540c - Lower Paper Exit Sensor

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 209
4.10.6 Lower paper exit sensor (S63)
(6) Take off the upper exit tray paper full
detection sensor [1] from the sensor bracket.
(7) Release the harness from the clamp and
then disconnect the connector.
(8) Remove 1 screw and disconnect the
connector. Then take off the sensor bracket
[2].
(9) Take off the upper paper exit sensor [3] from
the sensor bracket.
Fig. 4-605
(1) Take off the left top cover.
 P. 4-4"4.1.10 Left top cover"
(2) Lift up the reverse path cover and then
disconnect each connector of the lower exit
section cooling fans-1 and -2. Then release a
harness from a clamp.
Fig. 4-606
(3) Remove 2 screws and disconnect a
connector. Then take off the lower paper exit
roller unit.
Fig. 4-607
[
1
][
2
][
3
]
Lower paper exit roller unit