Toshiba E-Studio 5540c - Original Width Detection Sensor-1; Original Registration Sensor; Original Exit Sensor

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 294
4.11.42 Original width detection sensor-1 (SR6)
4.11.43 Original registration sensor (SR5)
4.11.44 Original exit sensor (SR12)
(1) Take off the feeder lower guide unit.
 P. 4-292"4.11.39 Feeder lower guide unit"
(2) Disconnect 1 connector. Lift the actuator,
release 2 latches and take off the original
width detection sensor-1.
Fig. 4-857
(1) Take off the feeder lower guide unit.
 P. 4-292"4.11.39 Feeder lower guide unit"
(2) Disconnect 1 connector. Release 2 latches
and take off the original registration sensor.
Fig. 4-858
(1) Take off the assembly of the exit guide and
the exit/reverse guide.
 P. 4-264"4.11.11 Exit guide / Exit/reverse
guide / Reading end guide"
(2) Remove 2 screws and take off the 2 leaf
springs.
Fig. 4-859
Original width detection sensor-1
Original registration sensor