Toshiba E-Studio 5540c - Tension Roller; 2 Nd Transfer Facing Roller

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 151
4.7.12 Tension roller
4.7.13 2nd transfer facing roller
(1) Take off the transfer belt.
 P. 4-146"4.7.7 Transfer belt"
(2) Remove 2 collars [1].
Fig. 4-442
(3) Move the bearing [1] to the inner side and
then take off the tension roller [2].
Fig. 4-443
(1) Take off the transfer belt.
 P. 4-146"4.7.7 Transfer belt"
(2) Remove 2 screws and take off the lever
assembly.
Notes:
When the transfer belt unit or the lever
assembly is replaced, be sure to perform the
adjustment of the degree of parallelization for
the transfer belt unit.
Do not remove the 2 red screws unless the
adjustment is necessary.
Fig. 4-444
[
1
]
[
1
]
[
2
]
Lever assembly