Toshiba E-Studio 5540c - Transfer Belt

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 146
4.7.7 Transfer belt
Notes:
It is recommended to wear gloves to avoid a direct touch on the belt surface.
(1) Take off the transfer belt unit.
 P. 4-144"4.7.6 Transfer belt unit (TBU)"
(2) Pull up the belt guides [1] by approx. 20
degrees and then pull them out to take them
off.
Fig. 4-426
Notes:
When installing the belt guide, tilt it by
approx. 20 degrees and insert it to the shaft,
and then let it go down under its own weight.
When it does not go down under its weight,
reinstall it because the belt might get on the
rib of the guide.
Fig. 4-427
(3) Remove 1 screw and a stay [1].
Fig. 4-428
[
1
]
Belt guide
Pulley
Transfer belt
Rib
Belt guide
[
1
]