e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 114
4.6.26 Developer sleeve
Notes:
Normally developer material does not need
to be replaced. If there is a need for
replacement, follow the procedure below.
1. Scrape off developer material adhering to
the magnet sleeve by rotating the
coupling.
2. Install the developer unit into the
equipment and attach a developer
material to the sub-hopper.
3. Turn the power of the equipment ON
while pressing [0] and [5] simultaneously.
Then perform the code 2400.
4. Install the sub-hopper after developer
material has been filled up.
(1) Take off the Developer unit.
P. 4-110"4.6.24 Developer unit"
(2) Release 2 latches and take off the cover.
Fig. 4-334
(3) Release the latch and take off the recovery
roller.
Fig. 4-335
To Next Page
Loading...
