e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
7 - 78
7.13 Machine Refreshing Checklist (e-STUDIO5560C/6560C/6570C
only)
Symbols/value used in the checklist
Notes:
• When performing machine refreshment, check the items in the preventive maintenance checklist
in addition to the items in the machine refreshing checklist.
• Perform cleaning and lubricating in the following timing. Lubricate the replacement parts
according to the replacement cycle.
• The value in the “Replacement” field of the table below indicates the replacement number of
output pages in either the black or the full color mode.
• The replacement cycle of the parts in the feeding section equals to the number of sheets fed from
each paper source.
• Be careful not to put oil on the rollers, belts and belt pulleys when lubricating.
•
Parts list <P-I> represents the page item in
“e-STUDIO5560C/6560C/6570C Service Parts List”.Item Description
Cleaning A: Clean with alcohol
B: Clean with soft pad, cloth or vacuum cleaner
Lubrication/
Coating
W1: White grease (Molykote EM-30L)
Replacement Value: Replacement cycle
R1: Replacement
R2: For preventive maintenance, check if the parts are damaged and replace
them as required. If the parts are not replaced at the machine refreshing
interval, inspect them at the subsequent PM.
R3: Replace if deformed or damaged. If the parts are not replaced at the
machine refreshing interval, inspect them at the subsequent PM.
R4: Lubrication recommended: If the parts are not lubricated at the machine
refreshing interval, inspect their lubrication status at the subsequent PM.
Operation check O: After cleaning or replacement, confirm there is no problem.
Model Replacement cycle
e-STUDIO5560C 900,000 sheets
e-STUDIO6560C 1000,000 sheets
e-STUDIO6570C 1100,000 sheets
Items to check Cleaning
Lubrication/
Coating
Replacement
Operation
check
Parts
list
<P-I>
(x 1,000
sheets)
(x 1,000
drive
counts)
1 Drum drive unit
W1 R4 R4 -
2 Development drive unit
W1 R4 R4 -
3 Paper feeding drive unit
W1 R4 R4 -
4 Fuser drive unit
W1 R4 R4 -
I1 Transfer belt
AR2R231-33
I2 1st transfer roller
B R2 R2 30-58
31-23
I3 2nd transfer facing roller
A R2 R2 30-34
To Next Page
Loading...
