e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 254
4.10.52 Interlock switch (SW2)
Notes:
When the interlock switch is replaced or removed, be sure to perform the operation check with
the output check (test mode 03). If the installation is insufficient, this could cause an electric
shock.
(1) Take off the front lower cover.
P. 4-1"4.1.2 Front cover"
(2) Take off the right internal cover.
P. 4-133"4.6.49 Toner cartridge heat
insulation fan (F21)"
(3) Disconnect the connector [2] from the
interlock switch [1].
Fig. 4-739
(4) Remove 2 screws and take off the switch
bracket [1].
Fig. 4-740