Toshiba E-Studio 5540c - 2 Nd Transfer Roller; 2 Nd Transfer Roller Lubricant Unit

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 156
4.7.15 2nd transfer roller
4.7.16 2nd transfer roller lubricant unit
(1) Take off the 2nd transfer unit.
 P. 4-154"4.7.14 2nd transfer unit (TRU)"
(2) Remove the clip [1] on the front side and
then 1 bearing [2] and 1 bushing [3].
(3) Remove the clip [4] on the rear side and then
1 bearing [5] and 1 bushing [6].
Notes:
Since the bearing [7] is press-fitted in the
bushing [3] [6], be sure to remove it straight
so that it does not fall off.
Fig. 4-456
Notes:
2nd transfer roller differs by product.
This model does not have a D-cut on the
shaft edge.
• [1] No D-cut on shaft
Usage models: e-STUDIO5540C/6540C/
6550C, e-STUDIO5560C/6560C/6570C
• [2] With D-cut on shaft
Usage models: e-STUDIO5520C/6520C/
6530C
Fig. 4-457
(1) Take off the 2nd transfer roller.
 P. 4-156"4.7.15 2nd transfer roller"
(2) Remove 1 screw on the rear side and then
take off a bushing.
Fig. 4-458
[
1
]
[
2
]
[
3
]
[
3
]
[
4
]
[
5
]
[
6
]
[
6
]
[
7
]
[
7
]
[
1
][
2
]
Bushing