Toshiba E-Studio 5540c - Scanning Function

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING ADJUSTMENT
6 - 78
6.4.13 ADF noise reduction (Scanning Function)
The noise reduction level for streaks can be adjusted with the following codes when a scan job is
performed using the ADF while its scan noise reduction function is set to enable (*).
* When [LOW], [MIDDLE] or [HIGH] is selected in the [ADMIN] tab of the [USER FUNCTIONS] menu,
or when "0", "1" or "2" is selected in 08-8300.
<Adjustment Mode (05)>
Notes:
• Remember the image specifications and life span of the replacing parts may not meet the
standard when the setting value is changed from the default value.
• If too small a value is set, the text may not be printed clearly.
<Procedure>
The procedure is the same as that of  P. 6-71"6.4.2 Density adjustment".
Color
Item to be adjusted Remarks
Original mode
Text
Printed
Image
Photo
Custom
mode
8414 8415 8416 8412 ADF noise reduction When the value decreases, the
effect of reducing streaks
becomes larger. When the value
increases, the effect of reducing
streaks becomes smaller.
When "0" is set, this function is
disabled.
Acceptable values: 0 to 200
(Default: 100)
Black
Gray
scale
Item to be adjusted Remarks
Original mode
Text/
Photo
Text Photo
Custom
mode
7401 7402 7403 7400 7404 ADF noise reduction When the value decreases, the
effect of reducing streaks
becomes larger. When the value
increases, the effect of reducing
streaks becomes smaller.
When "0" is set, this function is
disabled.
Acceptable values: 0 to 200
(Default: 100)