Toshiba E-Studio 5540c - Test Print Mode (Test Mode 04)

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 10
5.5 Test print mode (test mode 04)
<Procedure 1>
<Procedure 2>
<Procedure 5>
Notes:
1. When an error occurs, it is indicated on the panel, but the recovery operation is not
performed.
Turn OFF the power and then back ON to clear the error.
2. During test printing, the [CLEAR] button is disabled when “Wait adding toner” is displayed.
Remarks:
In the (Color selection) of <Procedure 2> and <Procedure 5>, the printing method is different
between [K(1)] and [K(4)] as follows.
• [K(1)]: Printing by bringing one K color developer unit into contact with the transfer belt.
• [K(4)]: The developer units of four (YMCK) colors are brought into contact with the transfer
belt, but the test pattern is printed in K color only.
* The number in parentheses indicates the contact of the developer unit and the transfer belt.
Refer to Chapter 15 in this manual for the codes available in the test print mode.
The embedded test pattern can be printed out in the test print mode (04).
[0][4]
[POWER]
[POWER]
OFF/ON
(Exit)
(Code) (Media selection)
[START]
[CLEAR]
Operation
Continuous
Test Printing
[0][4]
[POWER]
[POWER]
OFF/ON
(Exit)
(Code)
[START] [START]
[CLEAR]
[CLEAR]
Operation
Continuous
Test Printing
Color
selection
Media
selection
[0][4]
[POWER]
[POWER]
OFF/ON
(Exit)
(Code)
[START] [START]
[CLEAR]
[CLEAR]
Operation
Continuous
Test Printing
Color
selection
Media
selection
Input
density
[CLEAR]