e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 316
8.5.14 Skew (slantwise copying)
Fig.8-22
Cause/Section Step Check item Measures
Drawer/LCF 1 Is the drawer or LCF properly
installed?
Reinstall the drawer or LCF properly.
2 Is too much paper loaded in the
drawer or LCF?
Reduce paper to 550 sheets or less.
(Tandem LCF:
feeding side 1200 sheets or less/
stack,
standby side 1200 sheets or less/
stack)
3 Is the paper corner folded? Change the paper direction and
reinsert it.
4 Are the drawer or LCF side guides
properly set?
Adjust the side guides.
Paper feed
roller
5 Is the surface of paper feed roller
dirty?
Clean the roller surface with alcohol,
or replace the roller.
Rollers 6 Is each roller improperly fixed to the
shaft?
Check E-rings, pins and clips.
Aligning
amount
7 Is the aligning amount proper? Increase the aligning amount.
Registration
roller
8 Is the registration roller spring
removed?
Mount the spring correctly. Clean the
roller if it is dirty.
Registration
guide
9 Is the registration guide improperly
installed?
Correct it.
2nd transfer
front guide
10 Is the 2nd transfer front guide
installed properly?
Correct it.
RADF 11 Is the RADF installed and adjusted
properly?
Reinstall and readjust it.
Transfer unit 12 Is the transfer belt unit installed
properly?
Correct it.
To Next Page
Loading...
