8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 323
2nd transfer
contact/release
unit
(cam unit)
12 Is there any abnormality on the cam,
pusher and actuator?
Check if the cam, pusher and
actuator are installed correctly and
there are no damages on them.
Repair or replace them if needed.
13 Is the 2nd transfer pressure reduction
operating correctly during Thick
paper printing?
Invalidate the 2nd transfer pressure
reduction operation (change the
value from “1” to “0” for 08-4663.),
and check if the transfer failure is
cleared.
If it still persists, perform step 12
again.
Cause/Section Step Check item Measures
To Next Page
Loading...
