e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
11 - 40
(7) Turn the power OFF using the main power switch on the right-hand surface of the equipment and
remove the download jig.
(8) Install the board access cover.
[B] Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
P. 11-51"11.5 Confirmation of the updated data"
To Next Page
Loading...
