e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
EXTERNAL COUNTERS
13 - 4
4. EXTCTR signal (output signal)
The EXTCTR signal is synchronized with “Exit sensor ON” and becomes “Low” (ON) for specified
time. The coin controller counts the number of times with this signal.
This is the signal only for the coin controller.
Fig.13-3
5. BKCTR signal, MNCTR signal, FLCTR signal (output signal)
These signals become “Low” (ON) synchronizing with the CTRON signal according to the copying
mode used. The pulse width corresponds to the fixed time. Though the CTRON signal is set to
“Double count”, they are not outputted synchronizing with the second count signal.
6. SIZE3, SIZE2, SIZE1, SIZE0 signal (output signal)
These 4 signals are outputted in the combination of 4 sizes for the paper to be copied.
They are the signals for the coin controller, and are outputted from the LGC board.
7. LARGE/SMALL signal (output signal)
When large size paper (A3 / A3 wide / LD) is selected or paper size is not specified with the manual
feeding, it outputs “Low” in real time. In other cases, it outputs “High”. The setting change for large
size paper is performed with F/W.
This is the signal only for the coin controller.
8. FULL COLOR signal (output signal)
If the full color mode is selected, it outputs “Low” in real time. In other cases, it outputs “High”. By
default, it outputs “Low” since it is set as full color mode.
This is the signal only for the coin controller.
9. TWN / MON COLOR signal (output signal)
If the twin color or mono color mode is selected, it outputs “Low” in real time. In other cases, it
outputs “High”. This is the signal only for the coin controller.
10.B/W signal (output signal)
If the black mode is selected, it outputs “Low” in real time. In other cases, it outputs “High”. This is
the signal only for the coin controller.
OFF
ON
<EXTCTR>
Specifid time
<PIS-EXIT: Paper exit sensor>
With paper
Without paper
(Paper length / Feeding speed)
To Next Page
Loading...
