129
Fuser motor (normal rotation)
ON
179 Code No.129 function OFF 1
130
Bridge unit transport entrance
motor ON
180 Code No.130 function OFF 1
132
Reverse motor (normal
rotation) ON
182 Code No.132 function OFF 1
134
Reverse motor (reverse
rotation) ON
184 Code No.134 function OFF 1
136
Bridge unit transport exit motor
(normal rotation) ON (lower
Normal
speed
186 Code No.136 function OFF 1
138
Bridge unit transport exit motor
(reverse rotation) ON (upper
Normal
speed
188 Code No.138 function OFF 1
140
Exit motor (normal rotation)
ON (lower exit tray direction)
190 Code No.140 function OFF 1
142
Exit motor (reverse rotation)
ON (upper exit tray direction)
192 Code No.142 function OFF 1
144 ADU motor-2 ON
194 Code No.144 function OFF 1
146 ADU motor-1 ON
196 Code No.146 function OFF 1
*1
Fully pull out the EPU tray toward you while the transfer belt remains. If it is not fully pulled out,
the drum shaft and the drum flange may scratch each other and thus the flange may be worn
out.
*2
1. Pull the duplexing unit lever and then separate the transfer belt and the 2nd transfer roller.
2. Pull out the EPU (developer unit) tray until it comes to a stop while the transfer belt is left.
* Pull out the EPU tray completely otherwise the transfer belt and the photoconductive
drum may scratch each other.
3. Insert a door-switch jig into the cover interlock switch on the left upper side of the fuser
unit in order not to turn the 24 V power OFF.
To Next Page
Loading...
