e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 158
Notes:
When replacing the 2nd transfer roller side
seal, follow the procedure below.
1. Confirm that the gap between the 2nd
transfer roller cleaning blade and the side
seal on the front side falls within 0 mm to
0.5 mm.
2. Install the 2nd transfer roller side seal
following the standard shown in the
figure.
3. After the side seals are attached, move
the bracket retaining the blade and check
that it is neither caught nor comes up on
to the side seal.
Fig. 4-462
Fig. 4-463
Fig. 4-464
0~0.5 mm
2nd transfer roller side seal
(Front side)
2nd transfer roller
cleaning blade
0~0.5 mm
0~0.5 mm
2nd transfer roller side seal
2nd transfer roller
cleaning blade
2nd transfer roller side seal
2nd transfer roller cleaning blade
To Next Page
Loading...
