e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 180
(10) Release a harness from 2 clamps. Then
remove 1 screw and take off the front lamp
bracket.
Fig. 4-519
(11) Slide the pressure roller heater lamp to the
rear side to take them off.
Notes:
Follow the notes below to handle the
pressure roller lamp.
• When holding the lamp, grasp the glass
tube with gloved hands, but not the lead
wire and the edge.
• When installing the lamp, be careful not to
hit the protrusions on it or its edge against
the pressure roller. Do not forcibly pull or
move the lamp when its edge is fixed.
• Do not treat the lamp roughly, such as
letting it fall on the floor.
Fig. 4-520
(12) Remove the E-ring on the front side of the
drive roller shaft, and then pull it out from the
rear side.
Fig. 4-521
Clamp
Front lamp bracket
Clamp
Pressure roller heater lamp
To Next Page
Loading...
