e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 184
Notes:
1. When installing the gears of the fuser unit
in the field, pay attention to their direction.
2. Install GEAR-8H40-FMR with the
protrusion of the press-fitted one-way
clutch positioned outside as shown in the
figure on the right.
3. Install GEAR-8H35-8H30-FMR, which is
a two-step gear, with the larger one
having 35 gear teeth outside as shown in
the figure on the right.
Fig. 4-531
Fig. 4-532
(9) Remove E-rings on the both sides of the
fuser roller. Then remove a washer, a
bushing and a bearing.
Notes:
When installing the bushing, be sure to install
it in the proper direction and order.
Fig. 4-533
(10) Take off the heat pipe roller [1] from the
holder.
Fig. 4-534
GEAR-8H35-8H30-FMR
GEAR-8H40-FMR
GEAR-8H35-8H30-FMR
GEAR-8H40-FMR
Bearing
Bushing
Washer
Bearing
Bushing
Washer
To Next Page
Loading...
