4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 193
(8) Remove 2 screws and take off the bracket of
the pressure roller edge thermistor.
(9) Remove 1 screw each and take off each
thermistor bracket of the pressure roller
center thermistor and the pressure roller side
thermistor.
(10) Disconnect a connector.
Fig. 4-558
(11) Remove 1 screw and take off the pressure
roller edge thermistor.
Fig. 4-559
(12) Remove 1 screw each and take off the
pressure roller center thermistor and the
pressure roller side thermistor from each
bracket.
Notes:
When installing, make sure that the side of
the thermistor is correct.
Fig. 4-560
Fig. 4-561
Pressure roller edge thermistor
Pressure roller
center thermistor
Pressure roller
side thermistor
To Next Page
Loading...
