Toshiba E-Studio 5540c - Page 406

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 232
4.10.28 Reverse section stationary jam detection sensor (S58)
(1) Take off bridge unit exit roller-1.
 P. 4-225"4.10.21 Bridge unit exit roller-1"
(2) Disconnect 1 connector and remove 2
screws. Then take off the transport guide
unit.
Fig. 4-673
(3) Remove 2 screws and then take off the roller
guide.
Fig. 4-674
(4) Take off the bridge unit exit guide by
removing 2 screws.
Notes:
The type of the screw differs depending on
the installation position.
Fig. 4-675
Transport guide unit
Roller guide
Exit guide