e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 308
(5) Separate the finisher from the equipment
while pulling the lever.
Notes:
If MJ-1104 is used, separate the finisher and
then pull out the saddle stitch unit.
Fig. 4-13
Fig. 4-14
(6) Take off the cover.
Fig. 4-15
(7) Remove 2 screws and then take off the
cover.
Fig. 4-16
To Next Page
Loading...
