e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING ADJUSTMENT
6 - 86
(4) Disconnect 1 connector, remove 2 screws
and take off the SFB lower guide [1].
Fig.6-37
(5) Remove 1 screw from the round hole of the
front side bracket [1], and screw it
temporarily to an oblong hole.
Fig.6-38
(6) Move the front side bracket [1].
Move to the direction A: The roller life will
become longer (but multiple feeding may
occur frequently).
Move to the direction B: Multiple feeding will
be suppressed (but the roller life may
become shorter).
Notes:
The recommended moving distance of the
bracket is within 1 or 2 scale marks.
(7) Tighten the screw that was temporarily
screwed.
Fig.6-39
[1]
[1]
BA BA
[1]
To Next Page
Loading...
