8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 109
[EF22] Hole Punch Unit paper leading edge detection abnormality
[EF23] Hole Punch Unit paper alignment abnormality
Classification Error item
Finisher jam (Saddle section)
Check item Measures
Finisher • Is there any paper remaining on the paper transport path?
Is it staying at the position shown below?
• Figure out the cause of the paper stopping (e.g. folding)
and correct it. Then remove the paper.
Paper position sensor (S6-1/S6-2) • Sensor check
• Connector check
• Harness check
Punch controller board • Connector check (CN19)
• Board check
Replace parts Remarks
Paper position sensor (S6-1/S6-2)
Punch controller board
Classification Error item
Finisher jam (Saddle section)
Check item Measures
Finisher • Is there any paper remaining in the paper transport path in
the equipment or the Finisher?
Sideways deviation home position
sensor (S3)
• Sensor check
• Connector check
• Harness check
Paper position sensor (S6-1/S6-2) • Sensor check
• Connector check
• Harness check
Sideways adjustment motor (M2) • Motor check
• Connector check
• Harness check
Skew sensor
(S7-1, S7-2)
Skew sensor
(S7-1, S7-2)
Paper position sensor
(S6-1, S6-2)
Paper
To Next Page
Loading...
