e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 114
[C1C0] Option LCF tray-up motor abnormality
LCF end fence home position sensor • Sensor check
(Perform the input check: 03-[COPY]ON/[9]/[E])
• Connector check
• Harness check
LCF end fence stop position sensor • Sensor check
(Perform the input check: 03-[SCAN]ON/[1]/[E])
• Connector check
• Harness check
PFC board • Connector check (CN507)
• Board check
Replace parts Remarks
LCF end fence motor
LCF end fence home position sensor
LCF end fence stop position sensor
PFC board
Classification Error item
Paper feeding system related service
call
The option LCF tray-up motor is not moving normally
Check item Measures
Option LCF hook Check that the optional LCF is hooked by two positions on the
equipment.If it is not hooked securely, perform its height
adjustment.
Gaps between the equipment and
the optional LCF
Check that the gaps between the equipment and the optional
LCF on the upper and lower positions are even.
If the gap on the upper position is wider than that on the lower
position, perform height adjustment of the optional LCF.
Option LCF tray-up motor • Motor check
(Perform the output check: 03-270)
• Connector check
• Harness check
Option LCF tray-up sensor • Sensor check
(Perform the input check: 03-[SCAN]ON/[5]/[H])
• Connector check
• Harness check
LCF board • Connector check
• Board check
PFC board • Connector check (CN503)
• Harness check
• Board check
Replace parts Remarks
Option LCF bottom sensor
Option LCF top sensor
LCF board
PFC board
Check item Measures
To Next Page
Loading...
